iFi Audio

Mercury3.0 Single USB 3.0 Cable

Generic USB cables can have a negative impact on your enjoyment of music. Meet the iFi audio Mercury3.0. Maximum signal transfer. Minimum interference.

$209.00 - $269.00
More on the way!
Learn More
Join The Waitlist!
Bread Checkout

Not all cables are created equal
Looking for a cable with maximum signal transfer and incredibly wide bandwidth? Then the iFi Mercury3.0 is the cable you need. Standard mass-produced cables normally have the signal and power cables compacted closely together. This hinders conductivity and often results in poor signal transfer.

Not so with iFi's snazzy, new-look Mercury3.0 cable.

The Mercury3.0 cable separates the audio signal from the power with quadruple shielding to eliminate interference and jitter. It employs heavy OFHC continuous copper silver matrix conductors for the best possible signal transfer.

3.0 and proud!
The Mercury3.0 wears its ‘3.0’ with pride. USB3.0’s ultra-speed offers an incredibly wide bandwidth to allow for the speedier transmission of data. Efficiency at its best.

Cool, calm, collected. Custom.
Each iFi cable follows closely the tech specs of usb.org.

The Mercury3.0 custom minimum inductance parallel type with quadruple-shielding. This offers even more protection from RFI and EMI noise than the original. Sound quality is not compromised as with many ‘off the shelf’ versions where inadequate shielding is commonplace. Critically, the whole design hardly has a 5% tolerance to the 90ohm impedance rule.

Quality gold
The signal runs through the cable and the final connector. This connector must also be exceptional.

Most USB cables use molded plastic covered connections that do not shield the high frequencies present in the USB data link and noise radiates out. Very few manufacturers make their own connectors and rely mass-produced connectors which means durability is compromised.

iFi's FINAL USB connectors provide impeccable end-to-end RF (radio frequency) shielding. They are machined entirely from solid, aircraft-grade aluminum. Plus gold-plated connections make for years of steadfast service.


  • Construction: Minimu inductance parallel construction
  • Conductors: 24 and 28AWG
  • Conductor material: Heavy OFHC continuous cast copper silver matrix
  • Insulation: HD Polyethylene
  • Shielding: Quadruple-shields
  • Impedance: 90 Ohms (1% tolerance)
  • AC spark insulation: 1500V
  • Connectors: iFi ‘FINAL’ USB connectors
  • Insulation resistance: 100Mohm
  • Tensile strength: 1500PSI
More Information
Weight1.00 lbs
Warranty12 months
Product ManualDownload
Write Your Own Review
You're reviewing:iFi Audio Mercury3.0 Single USB 3.0 Cable
Your Rating
Copyright © 2020 Audio Advice. All rights reserved.