Available in pantone black or two-tone wood, JBL Stage is a stylish addition to any theater system. Whether it’s for movies or music, the sound of your home will never be the same. Featuring 1” aluminum dome tweeters with high-definition waveguide sound design and 8” woofers that register deep, signature JBL bass, the JBL Stage captures every note of the audio spectrum from high to low – and combines them into pure listening pleasure. 


Features
1" Aluminum Dome Tweeter w/ HDI Waveguide: The JBL Stage A190 floorstanding loudspeaker features a 1" aluminum dome tweeter with a High Definition Imaging (HDI) waveguide for lifelike high frequencies with clarity & accuracy.

Dual 8" Polycellulose Woofers:  The JBL Stage A190 floorstanding loudspeaker houses dual 8" polycellulose woofers with rubber surrounds that deliver deep, signature JBL bass performance.

Bass Reflex Cabinet: The floorstanding loudspeaker employs a bass reflex cabinet with dual rear-firing ports for greater efficiency and bigger bass response. The cabinet features MDF construction and is covered in black vinyl. It also includes a detachable cloth grille.

Dual Binding Posts: The JBL Stage A190 is fitted with two sets of sturdy binding posts allowing to bi-amp or bi-wire the floorstanding loudspeaker. These binding posts ensure a secure connection to many types of cable and connectors. The binding-post terminals will accept bare wire (up to 10AWG), pin connectors, spade lugs, and banana plugs (single or dual). Plastic caps will need to be removed to use banana plugs.

Bi-Wiring: Bi-wiring can provide noticeable improvements in the overall transparency of your loudspeakers. Run separate speaker wires to the low & high-frequency drivers from a single amplifier (the upper set of binding posts are for the high-frequency drivers; the lower set of binding posts are for the low-frequency drivers).

Bi-Amping: Bi-amping allows you to use separate amplifiers for the high & low-frequency sections of your loudspeaker for greater dynamic range & lower distortion. We recommend that your separate amplifiers have identical gain to preserve the speaker's voicing balance. Note: If you decide to bi-wire or bi-amp, you must remove the jumpers between the terminal posts (failure to do this could result in damage to your amplifier and loudspeakers).

Outriggers (w/ Rubber Pads or Spikes): The JBL Stage A190 comes with four outriggers that screw into the bottom of the speaker cabinet. You can screw the included rubber or spike feet into the bottom of the outrigger based on your type of flooring. The rubber pads should be used on hardwood, laminate, tile, and vinyl flooring. The spikes should be used on carpeted flooring.

Outriggers w/ Rubber Feet: 13.25" (w) x 43.9375" (h) x 17.5" (d)

Outriggers w/ Spike Feet: 13.25" (w) x 43.3125" (h) x 17.5" (d)
Note: The JBL Stage A190 floorstanding speaker should always be used with the outriggers and either the rubber or spike feet installed for better stability and sound performance.

Placement: A pair of JBL floorstanding loudspeakers should be placed approximately 6-10' apart and angled between 40-60° toward the listening position. Generally, bass output will increase as the speaker is moved closer to a wall or corner. JBL recommends that you place the speakers at least 20" away from side or rear walls.

Stage Series: The JBL Stage series delivers JBL signature sound for music and movie soundtracks. The Stage series consists of three floorstanding loudspeakers (A170/A180/A190), two bookshelf loudspeakers (A120/A130), two center-channel loudspeakers (A125C/A135C), and two powered subwoofers (A100P/A120P).